ETech Door Lock Series

. Main Features

·         Requires no PC/system to configure new member

·         Working Tempreture：-40℃ ~ +70℃

·         Working Humidity：20% ~ 80%

·         Power Consumption：Static≦ <15Ua

·         Low Votage Warning：<3.5V，red lights on，50 times operation remaining.

·         Finishing：□Brass â–¡Golden edge, silver body â–¡golden edge, chrone body

o        â–¡stainless steel   â–¡pearl golden   â–¡pearl silver   â–¡bronze

·         Card Key：64 digits password high safety i-button card、

·         Weight：3.4kg

·         Power supply：4 pieces of #5 AA alkaline battery（can last for over one year）.

III. Operating.

1、 Issue Authorization card

Touch one blank iButton card to the lock, blue lights on. Authorization card is issued successfully. (note: Authorization card itself can not open lock)

2、 Issue User card.

Touch the Authorization card first, while the blue light is flittering, touch a blank iButton card. A beep indicates the successful issuing of one user card. Repeat the above step to issue more user cards. Note: After you touch the authorization card, you can touch blank iButton card one by one to issue multiple user cards. Red lights with double beeps is the symbol of failure.

3、 Cancel user card/ clear authorization (when lose the user card or user card is illegally taken)：

Touch the Authorization card to the lock, hold it for 5 seconds, the lock keeps beeping, When a long beep available, withdraw the Authorization card, all the information in the lock was cleared, repeat step one and two to issue new Authorization card and user cards.

4.   Opening：

Touch user card, turn the handle after you get a ”beep” with blue lights. The motor will close automatically within 5 seconds after opening. Double “beep” indicates an illegal card.

5.  Set Passage Function：

Touch user card, after a beep, turn the handle to open the lock and blue light is flittering. Before the blue lights stops, touch the user card again and turn the handle to open the lock again, after a long beep, the passage function is set. The door lock keeps opened.

Cancel Passage Function.

Touch user card to it and you will bear a beep.(same as lock opening operation).

6.      Abnormal warning：

After opening the door, the lock automatically locks, if there is anything abnormal, it warns with “beep”

IV. Change battery

When the battery Voltage is lower than 3.5V，red light flitters，new battery is needed.( in this case, it can still support 50 times operation).

V. Maintenance

1. The cleaning of lock surface

Wipe up the lock surfaced regularly with soft and clean dry cloth. Do not use water, alcohol or any other chemical material that can damage or rust the lock.

2.  Lubricate.

In case the lock does not work smoothly, pleas lubricate the mechanical parts especially the cylinder.

3.  Change Cover and Handles

In case the cover and handle was scratched, you need to change them.

IV. In Addition

1、 Do not use acid battery other than 1.5 v alkaline battery.

2、 Installation of the lock should be done after the room decoration.

3、 Keep the lock out of acid or any other acid material；

4、 Handles should be protected in the cover before installment；

5、 Do not dismantle the lock yourself, it has to done by professionals or appointed persons；

6、 The lock and its functions will be updated frequently, please inquire from the company for updated information。

7、 Any customized requirement will be added as per customer request.